when did sinners come out - Roya Kabuki
Thread the Fan Clutch Nut: Hand-thread the large fan clutch nut onto the water pump shaft. Remember its likely a reverse thread, so turn it counter-clockwise to tighten initially.
Thread the Fan Clutch Nut: Hand-thread the large fan clutch nut onto the water pump shaft. Remember its likely a reverse thread, so turn it counter-clockwise to tighten initially.
Sorry to beat a dead horse here, I have a big wrench to fit the nut so I can get some good leverage, but cant seem to keep the pulley from slipping to crank on it.
The process involves: Placing the wrench flat on the fan clutch (0:07 - 0:10). Applying tension to the belt by using a tensioner tool in the opposite direction of loosening the fan clutch...
Understanding the Context
A bad fan clutch can cause your engine to overheat or lose power, so replacing it is an important maintenance step. Tighten the new clutch by hand first, then snug it securely using the.
The fan nut is a left hand thread, which naturally wants to tighten as the engine runs. So as long as you snugged it up good (and it sounds like you did) you are good to go.
It is important to use the correct fan clutch for the specific vehicle application for proper cooling and to avoid damage to the vehicle. Always check for and replace a damaged fan or water pump when.
Once hand-tightened, use the fan clutch wrench and a ratchet to firmly tighten the nut to the manufacturers recommended torque specification. Over-tightening can cause premature failure,.
Key Insights
Today I show you exactly how to remove and replace a fan clutch assembly with the proper tool!
Well, I just came up with this trick that makes the Fan Clutch Nut Install in 10 seconds! It was a breeze! - Remember that this NUT is reverse thread, so turn it Counter-Clockwise to tighten it. .
Position the fan on the clutch exactly as the original was removed. Install and tighten the fan bolts or nuts. Torque 6mm bolts or nuts 3 5 ft.lbs (5.0Nm). Torque 5/16 bolts. 15 18 ft.lbs (20-24Nm).
